is this hard
Thread Starter
Member
Joined: Jun 2006
Posts: 134
Likes: 0
From: west islip NY
Car: 86' Z28 Camaro
Engine: 350 holly 650cfm carb
Transmission: 700R4
Axle/Gears: 3:73 posi
is this hard
how hard is it to put a 86 trans am dash and gauges into a 86 z28 camaro??my friend has a t.a and i lov the gauges i wanted to put the whole dash and gauges into my camaro.
Banned
Joined: Sep 2005
Posts: 99
Likes: 0
From: York
Car: 84' z28
Engine: Built 350 SB 4 Bolt, Bored .30 Over
Transmission: 700r4
Axle/Gears: 3.42
i'd imagine if you had wireing diagrams for both of them it shouldnt be that hard to figure out if you put your mind to it
Senior Member
iTrader: (1)
Joined: Jun 2006
Posts: 692
Likes: 1
From: Oviedo,Florida
Car: 86' Trans am
Engine: 85 LG4-non cc carb(building a 350)
Transmission: Rebuilt 700R4,vette servo,2200stall
Axle/Gears: 2.73 Posi
u like my interior that much well i looked in the haynes camaro manual and all the wireing matches mine so save your money and well go to the junk yard and get it and ull be the only camaro wit t/a interior lol p'z
Thread
Thread Starter
Forum
Replies
Last Post
RedLeader289
Tech / General Engine
10
May 28, 2019 01:47 PM
