im pretty sure that im going to get a switch panel for my ign., fans, fuel pump and other stuff on my car to simplify the wiring but i was wondering id any one had an idea of where to mount it, one idea i have was right above the HVAC controls, or maybe replace them if i dont run them, heres a pic of the panel i was htining of getting, its 6-1/4" wide x 2-1/2" high

 

i think your ideas would be the best two places to make it look good

 

yea, i was hoping to get some other suggestions or pics

 

Could you hide it within the center console? I'm not sure of the measurements there but it seems like it would fit.

 

i like putting them where i can reach the fuel and ignition switches in case of problems at the track, unfortunately with my 5 point harness that would be too far of a reach with them being by the hvac, so i mounted them near where the fog light switch would be, since I don't have a factory fog light switch.

 

thats a good thing to consider, i have the fog light switch, but no fog lghts so that is a possiblity, do you have any pics of it?

 

id have to say lose the radio and put it there, or buy seprat switches and mount them on the center consol where the window switches are, or should be. could got under the center air vents put againt the virtical part of the dash... theres lots of places...