How do you remove the rear seat
Thread Starter
Senior Member
Joined: May 2006
Posts: 529
Likes: 0
From: Bartlesville, OK
Car: 2011 Cummins HO
Engine: 350 HSR
Transmission: T-56
Axle/Gears: 3.43
How do you remove the rear seat
I got the bottoms out no bother but i dont know how to remove the seat backs.. It is a split folding affair... 92 Z28.
Any ideas?
Search yeilded 0 results...
Any ideas?
Search yeilded 0 results...
Supreme Member
Joined: Jul 2001
Posts: 1,731
Likes: 0
From: LaFayette, NY
Car: '10 Subaru Forester
Engine: 2.5 Boxer
Transmission: 4EAT
Axle/Gears: 4.44
There is one bolt on the outer side of each seat holding the backs on, I'm sure you found those. The middle part of each back is fitted onto a bar sitting across the top of the driveshaft tunnel, you have to slide it off of the bar horizontally to remove each half by carefully angling it so as not to bend the metal fitting inside... or if you don't care about re-using the backs you can just bend the outer edge of the seat forward toward the center console and push it off of the bar... that's what I did because mine were completely shot.
Thread Starter
Senior Member
Joined: May 2006
Posts: 529
Likes: 0
From: Bartlesville, OK
Car: 2011 Cummins HO
Engine: 350 HSR
Transmission: T-56
Axle/Gears: 3.43
There is one bolt on the outer side of each seat holding the backs on, I'm sure you found those. The middle part of each back is fitted onto a bar sitting across the top of the driveshaft tunnel, you have to slide it off of the bar horizontally to remove each half by carefully angling it so as not to bend the metal fitting inside... or if you don't care about re-using the backs you can just bend the outer edge of the seat forward toward the center console and push it off of the bar... that's what I did because mine were completely shot.
Aha... no, hadnt found that bolt but i hadnt really looked that much either.. I found it now though.
Thanks,
Richard.
Thread
Thread Starter
Forum
Replies
Last Post
