New gauges
Thread Starter
Junior Member
Joined: Mar 2007
Posts: 15
Likes: 0
Car: Camaro z28
Engine: 350 TPI V8
Transmission: Automatic
New gauges
Hey guys if i bought Autometer gauges or w/e, then how would you hook them up ? Like how yould you get the connection to them from the stock ones?
Member
Joined: Oct 2006
Posts: 187
Likes: 0
From: Fallon, NV
Car: 91 Camaro RS
Engine: Small Block
Transmission: TH350 w/ 3000 stall convertor
Axle/Gears: 3.73 w/ powertrax locker
Re: New gauges
Lots of time and a 12 pack
I used a multimeter and tracked down all the wire going into the circuit board on the back of the gauge cluster, label each one and re-wire them to your autometer gauges. About all you'll need to do for each one is run a ground and power, and of course illumination lights in series. Then run the extra wires, like speedometer sensor, tach sender, oil pressure, water temp, etc. etc. Just take alot of time.
I used a multimeter and tracked down all the wire going into the circuit board on the back of the gauge cluster, label each one and re-wire them to your autometer gauges. About all you'll need to do for each one is run a ground and power, and of course illumination lights in series. Then run the extra wires, like speedometer sensor, tach sender, oil pressure, water temp, etc. etc. Just take alot of time.
Thread
Thread Starter
Forum
Replies
Last Post