A few questions... need recommendations
Thread Starter
Junior Member
Joined: Nov 2008
Posts: 44
Likes: 1
From: Sandston, Virginia
Car: '91 Trans-Am GTA
Engine: 305 5.0L V8
Transmission: 4-Spd Auto
A few questions... need recommendations
So I'm looking to swap out the black/grey interior of my '91 T/A to all black. I've found good sites for carpet and mats and a headliner, and I figured I could just paint the plastics with some adhesive promoter and interior paint.
Now, the seats I have are grey and I want to recover them, but I have 4th gen front seats and stock 3rd gen rears. I've heard that the rears are the same in both gens, so would a set of covers for a 4th gen interior work in my situation? or do I need to buy seperate covers for the rear bench?
Also, my door panels are like two different shades of grey and black, and I don't want to paint that vinyl because it will fade and peel. So anyone know where I can get black door panels? And on that note, where can I get cheap seat covers?
Thanks.
Also, where can I get black seat belts?
Now, the seats I have are grey and I want to recover them, but I have 4th gen front seats and stock 3rd gen rears. I've heard that the rears are the same in both gens, so would a set of covers for a 4th gen interior work in my situation? or do I need to buy seperate covers for the rear bench?
Also, my door panels are like two different shades of grey and black, and I don't want to paint that vinyl because it will fade and peel. So anyone know where I can get black door panels? And on that note, where can I get cheap seat covers?
Thanks.
Also, where can I get black seat belts?
Senior Member
iTrader: (1)
Joined: Feb 2009
Posts: 972
Likes: 2
From: La Grange Park, IL
Car: 1987 Iroc Z28/ 1982 Z28
Engine: 355 TPI IP/ 305 CFI
Transmission: T-56/ 300C
Axle/Gears: 3.42 Open/ 3.73 Posi
Re: A few questions... need recommendations
make the door panels, it sounds funny but our door panels are a joke, i mean literally all u need is half a brain, 2 sheets of masonite board and the material and a small amount of stuffing.
Thread Starter
Junior Member
Joined: Nov 2008
Posts: 44
Likes: 1
From: Sandston, Virginia
Car: '91 Trans-Am GTA
Engine: 305 5.0L V8
Transmission: 4-Spd Auto
Re: A few questions... need recommendations
Ya, I've seen quite a few people saying that around the forums. I might just make it a solid piece of black vinyl and just attach the arm rest, door handle and the little trim piece. I think that might look plain though.
Thread
Thread Starter
Forum
Replies
Last Post




