getting 4th gen leather seats for my 91 RS, will look nice as hell, but how do i install them? i know they bolt in, but the driver seat is electric, so how do i wire that up? my previous seats were not power operated so i'm assuming there's no wiring existing where my driver seat is, thus how would i wire the new seat in to make it functional??? sorry if this sounds stupid, i'm not electrically inclined...

 

Bump because i'm wondering the same thing. I have 4th gen seats in and idk how they are supposed to be wired.

 

if theres only two wires one will be the hot and the others the ground.

 

SO IT IS TRUE they bolt right on in no problems? if thats the case im juiced im not electrical

 

Front & rear are direct bolt-ins. Just hafta wire power to them when they are electrical seats.

 

nice how much did you pay

 

Actually it's easier if you replace split rear fold down seats with split rear fold down seats and the solid fold down with the like as well. Also, mine wasn't power to begin with and my seats from a 4th were, so I wired them to the cigarette lighter.. piece of cake. Stone

 

just put in a hot wire to the fuse panel and make yourself a ground