chevyscottsdale

The guy I bought my camaro from removed the interior so he could make the car lighter. I'm needing to find seats and other interior pieces for relatively cheap. Anyone have any suggestions on where I should start looking? Thanks

travis401

iTrader: (1)

local junkyards. 4th gen seats are a direct bolt in and are more comfy than 3rd gen seats. you can pick up a complete set, front and back, for around $100.

chevyscottsdale

Last time I was out at the junkyard I couldn't find any Camaro's that had the seats. I know the Trans Am is the about the same as a Camaro, are their any other interchangeable models?

Project 3.4 Camaro

If you're near pittsburgh, PA, I have pretty much all the interior plastics(black) only pieces I plan to keep or the sill plates, and center console I don't have the carpet though. I've got some rear seats as well, grey cloth with a diagonal pattern on the edges, single piece fold down back, split buckets, could use some cleaning up, but no damage on them if memory serves.

FueledSoul

iTrader: (18)

All 1982 - 2002 F-body (camaro/firebird) seats are direct bolt on.

majobis

iTrader: (3)

I agree with Travis. My interior parts were mostly trashed and after hitting up a few donor cars, I got pretty much everything I needed, including spare pieces. It's dirt cheap at 'pick/pull your own' salvage yards - especially when it's not motorized or electronic. Ebay has everything too, but you end up paying more after shipping. Craigslist is great too. Under the 'auto parts' category, type in Camaro. I usually find people looking to part out vehicles there. Lastly, go with the 4th gen seats if you can; I'm glad I did.

chevyscottsdale

Wish I was but I live in TX which is about as far away for Pittsburgh as you can get. lol

Project 3.4 Camaro

yeah, quite literally opposite corner of the country....

chevyscottsdale

Thanks for all the suggestions/advice. I'll look into trying to find some 4th gen seats. The guy I'm getting it from should have his engine/tranny out in the next week, then I get to start on my newest project.

58mark

iTrader: (3)

What part of texas? I can hook you up with a full set for$ 50

chevyscottsdale

Abilene, which is about 200 miles west of Dallas

camaronewbie

seats here - here's been many different seats used besaides 4th gen seats - will give you more options (I believe Cavelier seats, etc. have been used).

58mark

iTrader: (3)

I wouldn't want to ship seats, but if you can make it to dallas i'll hook you up cheap

Nice set, drivers side is the only one that isn't perfect, and even it isn't bad

Project 3.4 Camaro

I think grand am seats bolt in too, in fact I think I recall one of the grand am sub models using the same seats TAs had, may be wrong on that though.

chevyscottsdale

58mark: PM sent

58mark

iTrader: (3)

it was nice meeting you this morning! glad my extra seat set is going to be put to good use. I hope you can make it out to next year's roundup!

http://thirdgenroundup.com

chevyscottsdale

I'll do my best! Hopefully going to start my build sometime next week so lots of work still to do.