Center console plastic
Thread Starter
Member
Joined: Mar 2011
Posts: 327
Likes: 0
From: Washington state
Car: White 84 z28
Engine: Chevy 350
Transmission: T5
Axle/Gears: Posi and?
Center console plastic
I have an auto car and was wondering how to take off plastic around auto shifter, 87 firebird if that helps
Senior Member
iTrader: (3)
Joined: Jul 2008
Posts: 634
Likes: 3
From: Massachusetts
Car: 1987 IROC Z w/T-Tops
Engine: 305 TPI
Transmission: Automatic
Axle/Gears: G92
Re: Center console plastic
I have a Camaro, but it should be the same. Take off the shifter **** (should be a small pin on the rear of the shifter - put into 1st gear for easier access and then pull upward to remove). Then, using a torx bit, remove the plate. Here's a link to an Ebay page of what it should look like (provided we're talking about the same part). http://cgi.ebay.com/ebaymotors/FIREB...Q5fAccessories
Joined: Nov 2010
Posts: 5,892
Likes: 84
From: Mantua NJ
Car: 1 Owner 1986 TA with a WS6 package
Engine: 5.0 EFI
Transmission: THM700R4
Axle/Gears: 277 Posi Speedo
Re: Center console plastic
Remove Two screws under the console lid,one under the ashtray then remove the shifter handle by pulling out the horse shoe type clip in the front of the handle,move the shifter back to drive lift up on the plate from the rear and guide it out to clear the radio pod,then remove the window and mirror switches and unplug the lighter and that's it.Good Luck.
OH and be careful with the switches they break easy!!!!!!!
OH and be careful with the switches they break easy!!!!!!!
Last edited by mantaguy; Jul 19, 2011 at 11:41 AM.
Thread
Thread Starter
Forum
Replies
Last Post
KNIGHTE
Southern California Area
6
Oct 22, 2015 09:11 PM