I started my Ls swap on my Camaro and been working on the wiring but I can't find the other side of this connector and was wondering if any know where or what it is.
Harness is of a 04 silverado

 

Black wire with white stripe is a ground, grey wire with black stripe is 4x4LOW engage signal to PCM, I forget what brown is for right off hand.

This connector can be removed and discarded fr the harness, it's nothing pertinent or useful to a thirdgen swap.

 

Thank you for response my project was stopped because I couldn't figure this out now I can get back to it

 

OK guys one more connector. Any clue?

 

Are you trying to use the truck fuse block as well?

I looked a a few harnesses I have here, and didn't see that connector anywhere in a engine harness, but I did find that connector in a partial body harness from a 04 I have. Sorry I can't help you with that one, I'm not sure what it is.

 

Believe or not I'm using the entire writing of the truck. The car had no wiring at all

 

Trace the wires back to the PCM connector and get the pin location.

If they don't go back to the PCM, you don't need them.