Hey all, I'm eager to get started on this swap. (Still waiting for them to pull everything out) but I wanted to hit the harness first as I wait for things to come in. It's coming from a 04 envoy. Just wanted to know where I should start. I know it needs separated just as pockets guide does but where should I start for the pinouts since I keep coming across just fbody/ls1 pinouts. Or is it basically the same thing?


Also if you see this pocket, when if at all will your pics be back up? Lol Also on a side note I might be interested in one of your harnesses. When it comes to wiring...... i just hate it alot. Haha

 

Here ya go. I have always used this. Just print them out and grab some beer lol

http://lt1swap.com/98-02_ls1.htm

Assuming you are using a 99-02 F-body computer. If not just look at the vortec wiring. I believe most is similar though.

My first build I used a vortec harness and pinned it for an Fbody PCM, the last one I did was a Vortec harness I de-pinned to start fresh and repinned (minus emissions)

Jay

 

It's from the envoy as well. So I'll go with the vortec one. Must have over looked this. This if absolutely amazing and should get her done. Once I get started I'll have to start a swap thread. Thank you!

 

nvm

 

Nvm I kept over looking what I needed

 

Photobucket resets mid month

 

I gotta get a hard copie next time it's up lol