Road Racing & Hyperfest ...
Thread Starter
Member
Joined: May 2001
Posts: 429
Likes: 0
From: Germantown, MD USA
Car: 87 T/A
Engine: TPI 350 ci
Transmission: 5 speed
Road Racing & Hyperfest ...
... coming to Summit Pt, July 10th & 11th.
The road racing & HPDE will be held on the Main circuit, while most of the Hyperfest will be on the Jefferson circuit. The 'drifting' competition, though, will be on the Main.
For more details, check out NASA-VA. I believe admission will be 15 bux to spectate all the activities.
I'll be there as an instructor on the Main circuit with PF Flyer, so if you come out, stop by the paddock area and say hello. Might even be able to provide a ride-a-long or two.
The road racing & HPDE will be held on the Main circuit, while most of the Hyperfest will be on the Jefferson circuit. The 'drifting' competition, though, will be on the Main.
For more details, check out NASA-VA. I believe admission will be 15 bux to spectate all the activities.
I'll be there as an instructor on the Main circuit with PF Flyer, so if you come out, stop by the paddock area and say hello. Might even be able to provide a ride-a-long or two.
Member
Joined: Jan 2001
Posts: 257
Likes: 0
From: Maryland *Again*
Car: 86 Trans Am WS6
Engine: 350 TPI
Transmission: 700R4
Hey Mike long time no see. I am about to rebuild my suspension using Spohn's Moog kit then I'm going to try my hand at road racing. I'll try and stop by one weekend to see the Flyer and show the TA off.
Thread Starter
Member
Joined: May 2001
Posts: 429
Likes: 0
From: Germantown, MD USA
Car: 87 T/A
Engine: TPI 350 ci
Transmission: 5 speed
... any time both garage doors are open, I'm there.
I also used Moog HD for the ball joints on the front A-arms. They're the best. Everything else up front is polyurethane.
Just be careful with the spring removal and note how the bolts go thru the strut mount to the spindle.
I also used Moog HD for the ball joints on the front A-arms. They're the best. Everything else up front is polyurethane.
Just be careful with the spring removal and note how the bolts go thru the strut mount to the spindle.
Thread
Thread Starter
Forum
Replies
Last Post
BumpaD82
Tech / General Engine
37
Feb 26, 2016 02:57 PM




