I Will Be Adding More Information And Pictures Tommorow And Block And Head Casting #'s.

For Sale Located In Waterloo,Iowa

Small Block Chevy 355 Engine Professionally built by Midwest Motorsports In Ames, Iowa.

This Motor Was Built For Boost And To Handle 800+HP

There Is Honestly Less Than 5 Miles On The Motor.

1977 SBC 350 Bored .030 Over - 4 Bolt Main
Eagle 4340 Forged H-Beam Rods
Eagle 4340 Forged Crank
Wiseco Forged Pistons - 8:5-1 Compression Ratio
ARP Bolts All Through The Engine
1971 LT1 GM 487 HD Heads - 2.02/1.60 Valves - 3 Angle Job Ported
Crane Cam 292/484 - 2200-5800 RPM Range
New Bronze Guides, Retainers And Locks.
1.6 Ratio Crane Roller Rockers
High Performance Springs
Thick Pushrods
Chrome Valve Covers
Moroso Chrome Air Cleaner
Nice Engine Stand Is Included Also

Engine Does Not Included The Following
Intake
Distributor
Flywheel/Flexplate
Starter

Over $4000 In Build Reciepts Included With Sale
Asking $2000 O.B.O Or Trade - See Below

May Will Trade For LT1/L98/Vortec 350 And Tranny Combo Or Possibly Another SBC Engine/Tranny Combo, forged pistons

Have Pictures Of Engine - E-mail Me To See Them

 

Why are you selling it

 

The reason I'm selling it is I took it in on a package with a Mazda Rx7 Thats Setup For A SBC/T-56 (Which is also possibly for sale), but the engine is basicly over-kill for what I want. I'm planning on only running 100-150 shot of nitrous, so I'd rather just sell it and get an engine/tranny combo thats better suited for my setup. Even on ebay the rotating assembly alone is $1800+ Shipping, and since again it was progressionaly put together by Midwest Motorsports. I know somebody out there is looking for a very stout engine, The crank is rated at 1200HP - So It will be a very bad-*** engine for whoever picks it up.

-Chris

 

i say keep it an use it. even if you wont push it to its limits you will have it there for any future performance improvements. better safe than sorry.

 

do u still got ??? very interested!?!?! check ur pm's

 

Yeah I still have it but was planning on using it in my Rx7, maybe we can work out a deal, I havent checked my PM's yet.

Chris

PS. I'm still open for other engine/tranny combo's, even a nice TPI/LT1 Motor And Tranny, Vortec 350 Longblock Minus Intake Plus A Tranny will Work Also.

I'm not AIM alot, if you need to get a hold of me try Yahoo, my screen name is NitrousJunkie427 - Thanks.

 

Believe it or not the thirdgen Chris and Sarah have is at my house. Also Chris have Sarah get Travis engine. That would be a nice change.