looking for shop to tune
Thread Starter
Member
iTrader: (1)
Joined: Dec 2010
Posts: 320
Likes: 0
From: Round Lake IL
Car: 1989 formula
Engine: 350 l98
Transmission: 700R-4
Axle/Gears: 327
looking for shop to tune
I live in round lake il around gurnee mills does any one no of any shops that do tpi tunning i have basic mods cai ud pulleys and air foil thanks
Supreme Member
iTrader: (8)
Joined: Jul 2001
Posts: 3,204
Likes: 7
From: New Boston, IL, USA
Car: '90 Formula 350
Engine: 383 SBC
Transmission: ProBuilt S/S 700-R4 & ACT 9" Stall
Axle/Gears: 10 bolt 3.23
Re: looking for shop to tune
Is there all that much tuning that can be done on the stock computer?
Most of the tuning you could probably do yourself such as setting the TPS, adjusting the kickdown cable if it's out of adjustment, etc.
Most of the tuning you could probably do yourself such as setting the TPS, adjusting the kickdown cable if it's out of adjustment, etc.
Thread Starter
Member
iTrader: (1)
Joined: Dec 2010
Posts: 320
Likes: 0
From: Round Lake IL
Car: 1989 formula
Engine: 350 l98
Transmission: 700R-4
Axle/Gears: 327
Re: looking for shop to tune
not really sure new to this just seems like it runs really rich thought about getting a custom chip from hawks just not 100% sold
Supreme Member
iTrader: (8)
Joined: Jul 2001
Posts: 3,204
Likes: 7
From: New Boston, IL, USA
Car: '90 Formula 350
Engine: 383 SBC
Transmission: ProBuilt S/S 700-R4 & ACT 9" Stall
Axle/Gears: 10 bolt 3.23
Re: looking for shop to tune
It shouldn't be running rich just from the stock computer. Sounds like you need a tune-up from a shop or start troubleshooting yourself. The time mine started to run really rich I found a plug wire burnt in half. It fell on the header primary.
Thread
Thread Starter
Forum
Replies
Last Post