I'm looking for a COMPLETE LO-3 f-body only setup this is what I need

intake manifold with every thing as it was on the car

throttle body again must be complete and have air cleaner stud and hold down bolt

thermostat housing
fuel lines
accelerator cable

pretty much every possible thing so I can put it on my car without having to buy any other parts.

if you have a 350 throttle body this will be even better for me ... I am also interested in a smog legal aftermarket intake manifold as well.

please DON'T waste my time if you have junk I am only looking for nice stuff for this car

 

do you need the wiring harness computer..etc? I have a 1989 Formula tbi..running condition..thinking of swapping in a tpi engine...engine is still in the car and running...let me know make an offer

 

i have a 89 tbi set up (i was thinking of going to carb) it has a MSD billet dist. and MSD coil. factory intake though. i was tinking about trading it for a carb/dist/intake set up. it is still on the car and runs great i am getting atleast 20mpg with it. i am just trowing this out to see what happens.

 

ill ahve most everything out my car hopefully soon ... off of my 91 rs..


edelbrock tbi intake with chrome thermo housing
tbi unit with mods
k-n open element 14x3



harness and computer i have but will take a bit longer to get out.. .

 

no I dont need a harness at all already have one. just need the complete intake as it was on the running car, I'm mainly interested in only complete units.

No I do not need a distributor

this is going on my L-98 so if it has been mod'ed a little I'm sure my motor will be fine with it, if you have pics of your setups that is a plus

 

i can get some pics this weekend for ya...