TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

350 tpi ????

Thread Tools
 
Search this Thread
 
Old Feb 8, 2012 | 04:58 PM
  #1  
soarestransam's Avatar
Thread Starter
Senior Member
10 Year Member
 
Joined: May 2011
Posts: 855
Likes: 1
From: New Bedford MA
Car: 1988 Gta trans am
Engine: LR4 4.8
Transmission: 98-02 t56 6 speed
Axle/Gears: Bw 9 bolt (3.70’s) pbr rotors
350 tpi ????

Ok 350 tpi I finally got it running an Idling somewhat smooth my question is I'm getting some hesitation when I give it the throttle what could be the problem so far I changed wires, spark plugs an the cts
Reply
Old Feb 8, 2012 | 05:04 PM
  #2  
vetteoz's Avatar
Supreme Member
20 Year Member
iTrader: (13)
 
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: 350 tpi ????

Originally Posted by soarestransam
I finally got it running an Idling
what could be the problem
Some more info would be handy.

Is this a fresh install ,
a engine that had problems and was not running
or what.................??????????????????????
Have you checked the codes 1st?
Reply
Old Feb 8, 2012 | 10:27 PM
  #3  
soarestransam's Avatar
Thread Starter
Senior Member
10 Year Member
 
Joined: May 2011
Posts: 855
Likes: 1
From: New Bedford MA
Car: 1988 Gta trans am
Engine: LR4 4.8
Transmission: 98-02 t56 6 speed
Axle/Gears: Bw 9 bolt (3.70’s) pbr rotors
Re: 350 tpi ????

Sorry about the whole making a new thread of the same topic something weird happened saying it expired, ok so here's the situation when I first got the car home it was running really rough few ignition wires were cracked causing misfire, no 02 sensor was installed into the heddman headers so I fixed that the cts connector was broke fixed that, the motor has 111,000 on it oil pressure is around 30 psi, temp runs aroumd 190 an is steady no engine light is on at the moment. Starts up fine an idles it's just when I give it the throttle it takes a few seconds to climb up through the rpm's. I've replaced the spark plugs with ac delco r45ts with 10mm Taylor ignition wires. Havent got to change the cap an rotor yet for the dizzy, nor have I checked fuel pressure or checked the fuel filter, I do have a new fuel filter but I have to change acouple of lines fuel lines are starting to rot out pretty bad, alsO along with the brake lines

Last edited by soarestransam; Feb 8, 2012 at 10:32 PM.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
bamaboy0323
Tech / General Engine
25
Sep 3, 2015 06:07 AM
theurge
TPI
7
Aug 21, 2015 12:46 PM
Out-Cast
Tech / General Engine
5
Aug 17, 2015 10:57 AM
Jlanz55
Transmissions and Drivetrain
3
Aug 17, 2015 07:15 AM
bamaboy0323
Tech / General Engine
2
Aug 15, 2015 07:20 AM




All times are GMT -5. The time now is 01:23 PM.