Vortech belt help needed
Thread Starter
Member
iTrader: (5)
Joined: Sep 1999
Posts: 121
Likes: 0
From: Stillwater OK
Car: 88 IROC
Transmission: pg
Axle/Gears: 9" w/3.89
Vortech belt help needed
Ok everytime I go to put the sc belt back on it such a pain in the ***!! I have the standard 6 rib set up and I have put a smaller pulley on (2.95) and I'm using a 59.2in. long belt. My question is how do you guys go about putting your belts back on? I have had the belt on before. It just always take's 2 people to get it on. Please tell me there is a easier way. Thanks in advance
Member
Joined: Feb 2001
Posts: 277
Likes: 0
From: san antonio tx usa
Car: 84z28
Engine: chevy 388
Transmission: 700r4
i allways buy a belt a little bigger and dont have any probs putting it on.
you can see my simple site at:
http://darcom.org
you can see my simple site at:
http://darcom.org
Joined: Jul 1999
Posts: 12,100
Likes: 127
From: SALEM, NH
Car: '88 Formula
Engine: LC9
Transmission: 4L60E
Axle/Gears: 3.89 9"
1/2 inch drive breaker bar, and an 18MM wrench
Loosen the idler pully bolt for easier access to the tensioner bolt.
Put the belt on,. and pry back on the breaker.. Tighten the tensioner with an 18MM wrench, tighten the top pivot, then tighten the idler pully.
-- Joe
Loosen the idler pully bolt for easier access to the tensioner bolt.
Put the belt on,. and pry back on the breaker.. Tighten the tensioner with an 18MM wrench, tighten the top pivot, then tighten the idler pully.
-- Joe
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
