Well, iv recently been to a few junkyards, i found a 7.3 ford turbo... and a turbo coupe 5spd ... turbo

iv been wanting to run a turbo for awhile now
and last night i did some looking around my Camaro and some measuring seems like that this would be a good rote for a single
turbo "see pic"... with less work for me... this well be going on a 305 TBI Camaro... btw, im well a where of the work that all be putting into this
im not sure if all the work well be wroth anything????... ok with the 7.3 turbo on a 305 when well it start spooling up, then droping off?
same with the turbo coupe isn't that a .63 turbo?
witch would be better to run for my application, everything being stock except headers and a few other odds and ends, what would be the simples cheapest way to do things with out replacing much... like injectors and what not.... maybe 6psi?

 

that exhaust tubing is running extremely close to mastercylinder. i would rethink. look at bbsdesigns setup, that i think is the absolute best singlt turbo setup you can go with!

 

i can only do so much in photoshop...
i gotta about 2.5" to 3" between the pipes and the master cly
i could also put heat shelid around it...

 

swap sides... get rid of a/c