Just looking for some ideas on where to intall the nozzel. I kinda want to hide the sytem as best as I can.

 

Is anyone running N20 on there TBI car? I seen the plate but I don't want to spend that much for a 100 hp.

I am just trying to find the best place to install the fogger so it will give even flow to both bores.

 

I would install it in the gold spacer ring directly in the middle of the 2 bores. I am running nitrous, but have the NOS plate, which IMO is a better setup for TBI.

 

what do you think about Making my own plate. But instead of using the bars just tap it for the fogger right in the center?

I have the edelbroke TBI manifold.

 

That would work, but it would be easier to do with the spacer ring and probably yield the same results. They have cheap TBI plates on ebay sometimes too. You could also drill into your filter top and put the nozzle there if you have enough hood clearance, but that would look funky IMO, lol. You could also make some type of "cold air" setup and just drill and tap the nozzle into the tube. If it were me I would look on ebay or somewhere that would sell you a nitrous tbi plate for cheap and go that route. It's all really up to what you want to do with the car

 

found a NOS Plate for it thanks for the idea.