BlowThru Carb directions needed
09-22-2006, 09:47 AM
#1
Junior Member
Thread Starter
Join Date: May 2006
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
BlowThru Carb directions needed
was going on. I was wondering if anybody can point me in the right direction. I'm trying to get a blowthru carb. Now I have a 750cfm 4150 DP. Do u guys know anybody that modifies them for cheap . I'm on a budget.
I don't have a third gen car but I do have a 305 engine. I'm getting a novi 1000 soon, but I'm gonna need that blowthru carb. thanks in advance
my project Chevy eXperimantal RS-7
I don't have a third gen car but I do have a 305 engine. I'm getting a novi 1000 soon, but I'm gonna need that blowthru carb. thanks in advance
my project Chevy eXperimantal RS-7
09-22-2006, 11:32 AM
#2
Member
iTrader: (1)
Join Date: Aug 2005
Location: Middle GA
Posts: 294
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1992 RS
Engine: Vortec Headed 383 9.6:1
Transmission: TKO600
Axle/Gears: 10 Bolt Posi 3.73
When I think forced induction I don't think cheap.
Carburetor Solutions Unlimited
These guys have a good rep on turbomustangs, and a lot of information can be found there (Welcome to Turbo Mustangs.com) on blow-thru set ups and a plethora of information on anything turbo.
Carburetor Solutions Unlimited
These guys have a good rep on turbomustangs, and a lot of information can be found there (Welcome to Turbo Mustangs.com) on blow-thru set ups and a plethora of information on anything turbo.
09-26-2006, 02:23 AM
#4
TGO Supporter
Join Date: Dec 2001
Location: ELIZABETH,PA,USA
Posts: 2,308
Likes: 0
Received 0 Likes
on
0 Posts
I just used a standard Mech. secondary Holley with solid floats so they do not collapse.. And make sure its sealed up well, if not when introduced to boost it will find a leak in a hurry.
Was running up to 9-10 lbs with no probelms. Likes alot of Pumpshot as well.
09-26-2006, 08:57 AM
#5
Member
iTrader: (1)
Join Date: Oct 2005
Location: Troy, Ohio
Posts: 245
Likes: 0
Received 1 Like
on
1 Post
Car: 1987 Trans Am
Engine: 383
Transmission: TH400
Axle/Gears: 9 bolt 4.11
Do it yourself. Always the cheapest route...
link w/ directions...
Blowthrough Carb How-To
Aren't I a nice guy? lol
that article should be stickied in the threads at the top of the forum
link w/ directions...
Blowthrough Carb How-To
Aren't I a nice guy? lol
that article should be stickied in the threads at the top of the forum
Last edited by Ol'Blue; 09-26-2006 at 09:03 AM.
Thread
Thread Starter
Forum
Replies
Last Post