msd

Reply Subscribe

Thread Tools

Search this Thread

Mar 9, 2010 | 08:26 PM

blklblsk8r16

Thread Starter

Junior Member

Joined: Dec 2006

Posts: 26

Likes: 0

msd

this prolly isnt the right section but i figured most n2o guys should know a little something about msd. my camaro is carburated and i just hooked up my msd 6al box and now my lights (headlights, dome lights, dashlights) flash. the motor is basically stock. no forced induction

Mar 10, 2010 | 03:46 AM

tom86iroc

Senior Member

iTrader: (1)

Joined: May 2008

Posts: 867

Likes: 1

From: pawtucket RI

Car: 1986 iroc

Engine: alum. head 350 supercharged

Transmission: 6speed

Axle/Gears: ford 9in 3.90 35 spline moser axles

Re: msd

where did you connect the power and ground for the box?

Mar 10, 2010 | 04:24 AM

J91

Supreme Member

Joined: Jan 2009

Posts: 1,126

Likes: 0

From: Columbus Ohio

Car: 91 Z28,64ImpalaSS4094spd,67 Galaxy

Engine: Dart 415Profiler hd,cmprlrs,Hlly750

Transmission: Built 700R4, 3200 stall

Axle/Gears: 3:89 Moser 9"

Re: msd

You are wired in wrong in a big way! Dis connect the power wire and grnd wire and start over!

Mar 10, 2010 | 10:24 AM

blklblsk8r16

Thread Starter

Junior Member

Joined: Dec 2006

Posts: 26

Likes: 0

Re: msd

i had a print out from msd that i followed when hooking this up. i ran the power and ground both to the battery, then the rest of the wires are run to the distributor. and i have the one grond wire coming out of the distributorand grounding out on the motor. do you thik the ground on the motor should go on the body? or maybe its just a bad ground