Power step down :(
Power step down :(
So in my young and dumb infinite wisdom I put a much to large CAM into my car.... now after people told me I would have issues and after two years of me saying NO NO NO.... guess what... YEP
Destroyed my valve retainers... so I currently have an Edelbrock Performer RPM Roller Cam, I need some good advice and what a sorry sorry fool would need, that will still work with stock chevy 350 heads....(# 14102193).
This is going to be a daily get to school and back driver, not a race car, more a cruiser, kids back and forth to school and daycare.
So some real serious (ole man, dad) needs to go into this, CAM is the cheapest way to get the job done, so whats the best one for what I need. I dont want to be stock if I can avoid it, but if need be so be it.
Destroyed my valve retainers... so I currently have an Edelbrock Performer RPM Roller Cam, I need some good advice and what a sorry sorry fool would need, that will still work with stock chevy 350 heads....(# 14102193).
This is going to be a daily get to school and back driver, not a race car, more a cruiser, kids back and forth to school and daycare.
So some real serious (ole man, dad) needs to go into this, CAM is the cheapest way to get the job done, so whats the best one for what I need. I dont want to be stock if I can avoid it, but if need be so be it.
Member
Joined: Sep 2010
Posts: 113
Likes: 0
From: NE Ohio
Car: 84 z28
Engine: 305 for now, lil more then stock
Transmission: 700r4 for now
Re: Power step down :(
https://www.thirdgen.org/forums/tpi/...idle-87-a.html this might point you in the direction you seeking
Thread
Thread Starter
Forum
Replies
Last Post
sailtexas186548
Problems / Help / Suggestions / Comments
2
Aug 24, 2015 10:11 PM
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM