When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Tech / General EngineIs your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
I'm installing the snout onto the crank and it is held in place by a bolt. I need to know if there is a special (or not so special) washer that goes on the bolt. And, what is the exact size of the bolt? It's on a 95 LT1. Thanks guys
Grade 8 markings, 7/16x20 bolt. The washer looks like it's standard grade 8 steel too. Note the washer was measured in metric and the bolt was measured in standard.
Grade 8 markings, 7/16x20 bolt. The washer looks like it's standard grade 8 steel too. Note the washer was measured in metric and the bolt was measured in standard.
Thank you. I have the correct bolt, but I don't have the washer. Any idea where to get one?
Well, I've cruised through the internet and found one washer, but its cost is out of site. $88.21, and it's used. I can have one made for half that price. So my next step is to find an LT1 at the junk yard.
