im lookin for a place in the dfw area that does engin work i hav a 305 and i want to get it stroked out to a 327 right now i have these as my spec:

PERFORMANCE MODS
-Converted from TBI to Holley 600 Vac. Sec. Carb
-Edelbrok Performer RPM intake manifold
-Crane 1.6 roller rockers
-Roller lifters
-041 cast heads
-milled down to a 59cc head to bump up the compression
-3 angle valve job
-bowl hugging
-bronze valve guides
-screw in studs
-Comp Cams springs, retainers, and locks
- ALL THE MACHINE WORK WAS DONE BY KIMM BARR RACE MOTORS
-GM Performance LT4 Hot Cam
-Duration: 218/228 @ .050
-Lift: .525/.525 w/ 1.6 rockers
-112 lobe separation
-NX Hitman kit (nitrous)
-100-200 HP rating
-NX Bottle heater
-Blow down tube
-NX purge
-10 lb Bottle
-MSD 6Al Ignition Box
-MSD Coil
-MSD Pro Billet Distributor
-MSD Ignition Wires
-Hooker shorty headers
-Custom y-pipe
-Flowmaster dual exhaust w/ 3.5 inch chrome echo tips
-Cut out on the exhaust
-Holley fuel pressure regulator
-Billet Timing chain
-K&N 14 inch open element air filter
-Moroso radiator reservoir