NE Florida machine shops
Thread Starter
Joined: May 2001
Posts: 364
Likes: 2
From: WI north
Car: 88 Firebird
Engine: 302 SBC
Transmission: T-5
Axle/Gears: 4.27 Dana 44
NE Florida machine shops
Anyone know of a good shop with good rates in NE Florida?
Jacksonville, Daytona, etc.
I called one in Jacksonville and they seemed pretty high. $80 to check the block and almost $20 a cylinder to bore with plates.
Jacksonville, Daytona, etc.
I called one in Jacksonville and they seemed pretty high. $80 to check the block and almost $20 a cylinder to bore with plates.
Junior Member
Joined: Mar 2002
Posts: 18
Likes: 0
From: brandon, fl
I'm not sure of any in ne fl....are you planning on being in fl if so check out www.fl-thirdgen.org it is a very good fl website and there are lots of helpful people on the board register and post your question there maybe some of the guys know of one
Thread Starter
Joined: May 2001
Posts: 364
Likes: 2
From: WI north
Car: 88 Firebird
Engine: 302 SBC
Transmission: T-5
Axle/Gears: 4.27 Dana 44
Thanks for the tip. That is too far though.
I got ahold of a phone book for Jacksonville and there were quite a few listed but I don't know any of them.
I got ahold of a phone book for Jacksonville and there were quite a few listed but I don't know any of them.
Thread
Thread Starter
Forum
Replies
Last Post