Time for an upgrade
Thread Starter
Member
Joined: Sep 2001
Posts: 400
Likes: 0
From: Buffalo, N.Y
Car: 1983 Z28 Clone
Engine: 350
Transmission: TH350
Time for an upgrade
Here's what i've got planned. I was going to get into the low 8's by beefing up the motor a little. A couple members advised me about suspension mods. I have to admit that up until this point I knew nothing about suspension. I've been reading posts for about 3 hours and feel like a pro
I cannot believe I never looked into the benefits of Reclocation Brackets/LCA's.
Well, My 60' foots are 2.3 - 2.4...
3.08 gears, street tires,one wheel peel,full tank of gas due to traction probs.
Here's what i've got planned. I must do this stuff on a low budget ......or I can't do them at all !!!! I just dont have the pockets.
Spohn Lower Control Arms $105
Lakewood LCA Relocation Brackets $ 65
36mm rear Stabilizer Bar (Used) $ 20
Energy Suspension Poly End Link Kit $ 14
Energy Suspension Poly Stabilizer Bushings $ 14
KYB gas-a-just shocks $ 54
12 Bolt Posi rear end (used) $150
3.90 Richmond Gears $180
Richmond Installation Kit $ 90
Labor to install Gears $250
Now i should hook....with some slicks of course...
Anyway to shave off some bucks???I'm not running a sway bar now.......and my shocks are shot..
Rob
I cannot believe I never looked into the benefits of Reclocation Brackets/LCA's.Well, My 60' foots are 2.3 - 2.4...
3.08 gears, street tires,one wheel peel,full tank of gas due to traction probs.
Here's what i've got planned. I must do this stuff on a low budget ......or I can't do them at all !!!! I just dont have the pockets.
Spohn Lower Control Arms $105
Lakewood LCA Relocation Brackets $ 65
36mm rear Stabilizer Bar (Used) $ 20
Energy Suspension Poly End Link Kit $ 14
Energy Suspension Poly Stabilizer Bushings $ 14
KYB gas-a-just shocks $ 54
12 Bolt Posi rear end (used) $150
3.90 Richmond Gears $180
Richmond Installation Kit $ 90
Labor to install Gears $250
Now i should hook....with some slicks of course...
Anyway to shave off some bucks???I'm not running a sway bar now.......and my shocks are shot..
Rob
Thread
Thread Starter
Forum
Replies
Last Post




