How do I remove the bumper supports?
Thread Starter
Member
Joined: Dec 2003
Posts: 393
Likes: 0
From: Iowa
Car: 94 Camaro
Engine: 380 sbc
Transmission: th400
Axle/Gears: 9" 4.11
How do I remove the bumper supports?
Could someone give me some directions on removing the bumper supports? I'm looking to save weight anywhere I can.
Before anyone says anything about it being a major safety hazard to myself or anyone else, this car is going to be TRACK ONLY most likely it will be trailered if for no other reason other than to avoid paying insurance and a new title every year. So not really a big need to worry about the safety issues.
Thanks
Before anyone says anything about it being a major safety hazard to myself or anyone else, this car is going to be TRACK ONLY most likely it will be trailered if for no other reason other than to avoid paying insurance and a new title every year. So not really a big need to worry about the safety issues.
Thanks
Supreme Member
iTrader: (7)
Joined: Mar 2001
Posts: 6,420
Likes: 5
From: Fort Mill, SC, USA
Car: '88 Iroc, '91 RS, and a '70 RS
Engine: 5.7 TPI; 5.0 TBI; ZZ4/T56 on the ag
Transmission: A4, A4, slated to be a T56
Pull off the front and rear bumper covers, then you'll see the honeycomb stuff attached to the bumper supports, held on by 4 bolts on each side- 8 bolts each front and rear. Loosen up those and the support will come right off. "Installation is reverse of removal."
Ed
Ed
Thread
Thread Starter
Forum
Replies
Last Post