Actual Pro-Kit Ride Height
Thread Starter
Supreme Member
iTrader: (2)
Joined: Mar 2005
Posts: 2,820
Likes: 5
From: East Tennesse
Car: 1991 RS Camaro
Engine: L03 (want LS1)
Transmission: 700R-4 (and T56)
Axle/Gears: 4th Gen 3.23 posi
Actual Pro-Kit Ride Height
I am thinking about Eibach Pro-Kit springs, but I don't want to drop too low. You some people post pix of their cars with Pro-Kits. I am going to measure mine at the front of the wheel well on the ground effects at the front and rear for comparison. This way, there isn't a problem with the measuring tape not being in the center of the wheel well. Mine is a 91, if there are any differences with the GFX. Pix of mine tommorow. It is dark. Thanks in advance.
Joined: Dec 1999
Posts: 5,964
Likes: 37
From: Hacienda Heights, CA
Car: 90 RS 'Vert, 88 IROC-Z, 88 Firebird
Engine: 305 ci tbi, 305 ci tpi, 350 ci tpi
Transmission: WC-T5, WC-T5, 700R4
Axle/Gears: 3.45, 3.27, 3.27
Measure from the centerline of the rim to the fender lip. Use a level in the vertical orientation or a plum-bob to make sure you have the tape measure vertical. I've posted the measurements of my car with Pro-Kits installed years ago.
Lon
Lon
Supreme Member
Joined: Jun 2001
Posts: 1,509
Likes: 0
From: Newark, Ca, USA
Car: 02 ws-6
Engine: 5.7 liter
Transmission: t56
I measured my height with my prokit with 17inch rims. i measured it from the ground to the highest arc on the fender.
left front-26.5
right front-26.5
left rear-27
right rear-27.25
left front-26.5
right front-26.5
left rear-27
right rear-27.25
Last edited by PHAT89TA; Oct 13, 2005 at 11:17 AM.
Thread Starter
Supreme Member
iTrader: (2)
Joined: Mar 2005
Posts: 2,820
Likes: 5
From: East Tennesse
Car: 1991 RS Camaro
Engine: L03 (want LS1)
Transmission: 700R-4 (and T56)
Axle/Gears: 4th Gen 3.23 posi
Cool. Thanks. I haven't had the time to get my measurements (that and I haven't remembered to). I'll list mine soon.
Thread
Thread Starter
Forum
Replies
Last Post
skinny z
Engine/Drivetrain/Suspension Parts for Sale
5
Oct 5, 2015 06:23 PM
