Pulling to one side
Thread Starter
Member

Joined: Jun 2004
Posts: 122
Likes: 1
From: San Antonio, TX
Car: '89 Flame red metallic GTA!!
Engine: L98
Transmission: 700R4
Axle/Gears: 3.27
Pulling to one side
Just put new ball joints, new front tires, had them balanced and had a wheel alignment done. The car drove perfect for about 10 days, now it is beginning to pull slightly to the left. I thought having the wheels aligned would cure the pull to one side. Should it? Or is there something I have overlooked that would cause it to do that? I know that I have to replace the front struts, would bad struts cause a car to go out of alignment already? Or is it possible that the place I took it to did a ****ty job of aligning the car?
Thanks for any info.
Thanks for any info.
Member
Joined: May 2002
Posts: 292
Likes: 0
From: BENSALEM, PA
Car: 88 FORMULA / 88 IROC
Engine: 355 / 355
Transmission: T5 / TH400
Axle/Gears: 10 Bolt-3.73 / 9"-3.90
It is possible one of your strut plates could have been left loose and moved. Most alignment shops will recheck your car within a week or so maybe you should give the shop a call..
Member
Joined: Jul 2005
Posts: 477
Likes: 0
From: Manchester: UK
Car: Was 3rd Gen now MustangGT
Engine: 302
Transmission: Auto
Axle/Gears: 3:73:1
Just check the tyre pressures as well, its a known fact alloys can lose air fast if theres a bad seal, low pressure can cause a pull.
Thread
Thread Starter
Forum
Replies
Last Post




