I have a 700r4 Spohn Torque arm/crossmember it is installed and all.But when I drive it,it sounds like the driveshaft is hitting something sometimes,not always. It also has the front and rear safety hoops. Can someone please help,thanks.

 

I would start by getting under the car and looking at the drive shaft. If its hitting something chances are good you'll notice what area its coming from.

 

I had the same issue.

I also had all 6 crossmemeber holes drilled and tapped :-)

Anyhow, make sure your only using the original 4 holes, and then just loosen it to tweak the driveshaft loop until its dead centered in the tranny tunnel.

This seems to be the issue about 80% of the time. Just re-center it and check it out.

U chould be good to go

later
Jeremy

 

Ok ill try that thanks