strut removal
Thread Starter
Member
iTrader: (1)
Joined: Sep 2005
Posts: 324
Likes: 0
From: Arizona
Car: 91 Camaro RS
Engine: 305 tbi
Transmission: 700R4
strut removal
can someone help me out by telling me what tool im going to need to remove the bolt on top of the strut tower, i try to remove the bolt but it just keeps spinning, thx alot guys
Member
Joined: May 2004
Posts: 197
Likes: 0
From: New York
Car: 1992 Camaro Z28
Engine: 350ci
If the top of the threaded shaft (the actual strut rod) has two flat spots, just use a wrench to hold the shaft, while you use another wrench to loosen the nut. Just make sure you don't get your hand caught between the wrenches when that nut lets go. 
Supreme Member
iTrader: (7)
Joined: Mar 2001
Posts: 6,420
Likes: 5
From: Fort Mill, SC, USA
Car: '88 Iroc, '91 RS, and a '70 RS
Engine: 5.7 TPI; 5.0 TBI; ZZ4/T56 on the ag
Transmission: A4, A4, slated to be a T56
Read through and look at this link, it should help a lot:
Yahoo! Photos - taramiller72's Photos - 88 Camaro Rebuild
Ed
Yahoo! Photos - taramiller72's Photos - 88 Camaro Rebuild
Ed
Supreme Member
iTrader: (7)
Joined: Aug 2005
Posts: 1,068
Likes: 1
From: Ohio, near columbus
Car: 89 iroc-z
Engine: 305tpi
Transmission: wc-t5
Axle/Gears: 10 bolt 3.08 posi (4 now)
well i did mine on a 1992 a week or so ago and they used a metric allen to hold the top of the bolt.
Supreme Member
iTrader: (2)
Joined: Jul 2004
Posts: 1,678
Likes: 0
From: Miami
Car: 1992 Camaro RS
Engine: L03
Transmission: 700R4
Axle/Gears: Stock
I think mine were left hand threaded as well. I just did it last week but can't remember...
Last edited by ScottyRS; Jul 23, 2006 at 09:16 PM.
Thread
Thread Starter
Forum
Replies
Last Post
