the torque arm is mounted at too high of an angle?

------------------
89 Firebird (AKA "Money")
2.8 V6 w/ t5 tranny (383 tpi t56 12/01)
Flowmaster 80 series, 3" Intermediate, SS Tips, Random Tech Cat, Msd Coil, MSD 6a, Accel 8.8 wires, Cold Air Intake w/ K&N, Lakewood LCA's, Brushed aluminum Hood pins ETC...
Next:
Spohn Torque Arm, Lakewood Panhard bar, BMR Fabrication Sub Frame connectors...
-------------------------
My Site:
www.geocities.com/firebird89white

" I'd rather run last in a full out race, than to NOT run at all ".

 

basically as i understand it the torque arm controls how much force is exerted downward by the rear end. it would change traction, for the better or worse.

------------------
ICON Motorsports

1st & 3rd

 

That would change the instant center. The front mounting point of the torque arm is the instant center. Moving it up will increase %of rise, aka antisquat, in theory.

------------------
87 IROC 350, 3:42 Torsen, pocket ported 083 heads, complete Edelbrock exhaust, Most free mods, Most little mods, aluminum d/s. Edelbrock STB, SSM sfc's, boxed rear suspension pieces, urethane bushings everywhere.
Stock cam, chip, runners, base, and trans
13.94@103mph, 2.25 60'
In the works: ported SLP runners, ported base, Xtreme Cam, homemade suspension pieces, and 27x10 Hoosiers.
Goal: 12.999

 

Yea cuz my torque arm sits at a higher angle now for some reason and even if i dump at 4k it wont burn it hooks right up and doesnt squat either...!

------------------
89 Firebird (AKA "Money")
2.8 V6 w/ t5 tranny (383 tpi t56 12/01)
Flowmaster 80 series, 3" Intermediate, SS Tips, Random Tech Cat, Msd Coil, MSD 6a, Accel 8.8 wires, Cold Air Intake w/ K&N, Lakewood LCA's, Brushed aluminum Hood pins ETC...
Next:
Spohn Torque Arm, Lakewood Panhard bar, BMR Fabrication Sub Frame connectors...
-------------------------
My Site:
www.geocities.com/firebird89white

" I'd rather run last in a full out race, than to NOT run at all ".