How much support would a weld in 6 point roll cage provide compared to sub frame connectors. Both are weld in.
I want to get a roll cage but I will be putting out close to 500 horse in a firebird gta with T-Tops once i get it put back together.
Thanx in advance

 

Start with the SFC then put in the bar later. It's hard to compare one without the other.

------------------
Follow my racing progress on Stephen's racing page
and check out the race car

87 IROC-Z Pro ET Bracket Race Car
383 stroker (carbed) with double hump cast iron heads and pump gas
461 Big Block installed and ready for the 2001 racing season

Best results before the 383 blew up
Best ET on a time slip: 11.857 altitude corrected to 11.163
Best MPH on a time slip: 117.87 altitude corrected to 126.10
Altitude corrected rear wheel HP based on power to weight ratio: 476.5
Best 60 foot: 1.662

Racing at 3500 feet elevation but most race days it's over 5000 feet density altitude!
Member of the Calgary Drag Racing Association

87 IROC bracket car, 91 454SS daily driver, 95 Homebuilt Harley