Thump when braking
Thread Starter
Senior Member
Joined: Dec 1999
Posts: 770
Likes: 0
From: San Antonio, TX
Car: 86Z/92 RS Camaro
Engine: 357 vortec finished. need tuning
Transmission: Still works
Axle/Gears: need 3.73
Thump when braking
Today during a stop and go drive on I-5 (rush hour traffic) I noticed a single thump whenever I applied the brakes. Thump noise can be felt from the front drivers side floorboard. The thump noise can be felt more at lower speeds, say less than 5 miles.
Member
Joined: May 2001
Posts: 242
Likes: 0
From: Castle Rock, CO
Car: 89 Turbo Trans Am, '14 Forester XT
Engine: 3.8 Turbo V6
Transmission: 2004-R
Axle/Gears: 3.27
The same thing is happening to my car. I had it checked out and found it was the rubber bushing on the front of my torque arm. They said it will be a pain in the rear to fix it but you can get it done at a shop for about $250 bucks or so. Good luck.
------------------
1988 Camaro Sport Coupe
Coming soon...4th Gen Seats
------------------
1988 Camaro Sport Coupe
- 305 TBI
- 700R-4
- 14"x3" K&N Filter
- Flowmaster Cat Back System w/ 3&1/2" tips
- Y2K Origional Vette Rims
- Pioneer 6200 Deck
- 2 Kenwood 600 watts
- 2 Infinity Reference Subs
- Sony 3-way 6x9s in custom panels
- up to 137.0 dB
- "speed" stripes
Coming soon...4th Gen Seats
I felt a similer bump except it was during acceleration. It turned out to be the tranny mount bolts had come loose. You may want to check those.
------------------
'86 IROC 5-speed
305 LG4
edelbrock performer rpm intake
edelbrock 600 cfm carb
msd pro billet hei distributer
'95 3.23 rearend
hotchkis rear suspension
PST front polygraphite suspension
"speed kills. buy a f@&d, live forever."
------------------
'86 IROC 5-speed
305 LG4
edelbrock performer rpm intake
edelbrock 600 cfm carb
msd pro billet hei distributer
'95 3.23 rearend
hotchkis rear suspension
PST front polygraphite suspension
"speed kills. buy a f@&d, live forever."
Thread Starter
Senior Member
Joined: Dec 1999
Posts: 770
Likes: 0
From: San Antonio, TX
Car: 86Z/92 RS Camaro
Engine: 357 vortec finished. need tuning
Transmission: Still works
Axle/Gears: need 3.73
Thanks for the reply. As far as the "thump" goes it only does it once everytime I applied the brakes. I will check both the tranny mount bolts and torque arm bushing.
Thread
Thread Starter
Forum
Replies
Last Post
dbrochard
Engine/Drivetrain/Suspension Parts for Sale
6
Sep 19, 2015 08:13 PM





