hi, i just looked at UMI and they have a torque arm that replaces the stock one on 3rd gens,,,but what i like is that the the torque arm bolts to the transmission crossmember that they provide that replaces the stock crossmember...it actually elimintes stress on the tail end of a T5 or 700r4,,anyone out there have this on their cars?

 

I will have! I just got the T-5 relocation bracket today as a matter of fact. Should go nicely with the UMI TQ arm I already have...

 

ok,,you need the relocation bracket with an aftermarket torque arm...right?...the stock torque arm can't be bolted to this relocation bracket,,,what brand?...thanks...

 

AFAIK, the stock torque arm can but used with the relocation kits. The kit holds the factory clambshell, so i dont see what the factory arm wont continue to work.

 

what is the comapny that makes the relocation bracket?

 

UMI makes one, and i think BMR does too. Dont think Spohn does

 

Like //<86TA>\\ says, You can use a factory stamped steel arm with the relocation bracket, but you need to use a 1 piece poly bushing with it.

 

I have the UMI torque arm with the relocation kit on my car. I didn't keep the stock torque arm.

 

That's the one I just got along with a poly bushing! Any issues with the install? I have the UMI non-adjustable TQ arm too...

 

I got the adjustable one. I didn't come across any problems installing it. I do seem to notice a little more vibration from the car but nothing major.