DSE strut tower brace with Formula hood
Member
Joined: Jan 2014
Posts: 387
Likes: 143
Re: DSE strut tower brace with Formula hood
Don't think that will fit.
although I have not fit up a formula before.
My 3pt DSE STB rubs a tiny bit on my factory flat RS hood.(that's without under hood lining as well)
There have been a few guys who have cut the DSE brace down to lower the height.
So it's possible if you have some fab skills.
although I have not fit up a formula before.
My 3pt DSE STB rubs a tiny bit on my factory flat RS hood.(that's without under hood lining as well)
There have been a few guys who have cut the DSE brace down to lower the height.
So it's possible if you have some fab skills.
Thread Starter
Member
Joined: Mar 2017
Posts: 306
Likes: 49
From: Montreal
Car: 1989 Trans Am
Engine: L03
Transmission: 700R4
Axle/Gears: 3.42
Re: DSE strut tower brace with Formula hood
Don't think that will fit.
although I have not fit up a formula before.
My 3pt DSE STB rubs a tiny bit on my factory flat RS hood.(that's without under hood lining as well)
There have been a few guys who have cut the DSE brace down to lower the height.
So it's possible if you have some fab skills.
although I have not fit up a formula before.
My 3pt DSE STB rubs a tiny bit on my factory flat RS hood.(that's without under hood lining as well)
There have been a few guys who have cut the DSE brace down to lower the height.
So it's possible if you have some fab skills.
Thread
Thread Starter
Forum
Replies
Last Post