Anyone running the XR258HR cam
Thread Starter
Member
Joined: Mar 2002
Posts: 266
Likes: 0
From: Coushatta LA
Anyone running the XR258HR cam
Comp cam part # 08-500-8 206/212 .480/.488 112º LSA
Thinking of running it in a 350 TBI truck. Block has provision for a factory hydraulic roller. Mildly ported L98 iron heads,9.3:1 CR, thorley headers,Flowmaster 3 inch single catback, Edelbrock performer TBI intake,ultimate TBI mods, stock chip,4L60E,3.42's
Daily driver that will never see over 4500rpm. Wanting more torque/HP from idle to 4000 with the stock chip. Duration and LSA looks good but the lift seems a little higher than what i need.
What do you think? All opinions welcome
Thinking of running it in a 350 TBI truck. Block has provision for a factory hydraulic roller. Mildly ported L98 iron heads,9.3:1 CR, thorley headers,Flowmaster 3 inch single catback, Edelbrock performer TBI intake,ultimate TBI mods, stock chip,4L60E,3.42's
Daily driver that will never see over 4500rpm. Wanting more torque/HP from idle to 4000 with the stock chip. Duration and LSA looks good but the lift seems a little higher than what i need.
What do you think? All opinions welcome
Supreme Member
Joined: Mar 2001
Posts: 6,577
Likes: 0
From: Portland, OR www.cascadecrew.org
Car: 1990 Camaro RS
Engine: Juiced 5.0 TBI - 300rwhp
Transmission: T5
Axle/Gears: 3.42 Eaton Posi, 10 Bolt
should work fine.
btw, i have a ultradyne cam for sale, roller 206/216 .447 .447 112.
just thought i would toss that out there
btw, i have a ultradyne cam for sale, roller 206/216 .447 .447 112.
just thought i would toss that out there
Thread
Thread Starter
Forum
Replies
Last Post
1988iroc350tpi
Tech / General Engine
8
Aug 14, 2015 07:52 PM
