Just need some feedback on the setup I have chosen. My new motor should be done in a few days, and here are the components I have chosen.
Cam: 210intake/220exhaust
Heads from a 350 Tpi motor. Ported and 2 inch valves
Higher compression pistons should be 10:1!
Just need to know what Intake I should use?

I know I am going to need Computer tuning, But Funds are getting low, and I would like to know if this combo will run with stock computer just until I can tune?

Thanks everyone,
Dean:hail:

 

I would look for a carb intake of your choice. You will have to do a bit of searching to determine which one will best suite your combo. Your car may idle but that is about it with the stock chip. You risk doing serious damage to your motor when you have a combo like yours. Dirvabilty will be a mess, you will get like 2 mpg and you will have like 50hp.