i know that this is more of a general engine/tehc question but these are tbi heads so ii figured more of you would know will they clear 1.6 rockers sor will they need to have the pushrod hole enlarged?

 

to check this un hook your distribtor (power wire) or the battery and turn the motor over slowly by hand (prefibly your buddy can help) and watch the push rods go up and down in the slots. I know this sound stupid, but every set up is different. Thats how we do the race motors, and we can also check for proper pushrod lengh

later and

GB

rk

 

i knwo to do thanks anyway i was jsut hoping sumone has them or tried to put them on so i know before i buy then