What kind of hp do you think I'll be making?
Thread Starter
Senior Member
Joined: Oct 1999
Posts: 6,621
Likes: 2
Car: 91 Red Sled
Axle/Gears: 10bolt Richmond 3.73 Torsen
What kind of hp do you think I'll be making?
330hp vortec 350 (www.sdpc2000.com).
I have the tri-y SLP headers tell me if you need me to post a picture of them if you don't know what I'm talking about.
Air gap intake manifold with carb-TBI adapter. 454 TB w/all mods. Open air cleaner. 3" cat-3"borla single 3" out. Custom chip of course. I don't think I'll be making 330 since that was done with a 750cfm carb and full length headers. What little things could I do to get the extra hp?
------------------
, Jon (91 RS too many mods to list), getting new engine in summer
I have the tri-y SLP headers tell me if you need me to post a picture of them if you don't know what I'm talking about.
Air gap intake manifold with carb-TBI adapter. 454 TB w/all mods. Open air cleaner. 3" cat-3"borla single 3" out. Custom chip of course. I don't think I'll be making 330 since that was done with a 750cfm carb and full length headers. What little things could I do to get the extra hp?
------------------
, Jon (91 RS too many mods to list), getting new engine in summer
Senior Member
Joined: Jul 1999
Posts: 686
Likes: 0
From: Brevard Florida
I have a buddy with a similar setup that he installed in an early corvette. He is running comp cams # 12-243-3 226/234 @.050, .480/ .498 lift. He's had some problems getting it tuned for off idle... its got a carb and not enough gear... its very strong above 2000 rpm. Would work great in an efi car with gear and converter if automatic.
Thread
Thread Starter
Forum
Replies
Last Post
Thirdgen89GTA
History / Originality
2
Aug 25, 2015 06:40 PM
novaderrik
Transmissions and Drivetrain
3
Aug 10, 2015 12:44 PM
