Someone said this would be a good deal?? I was wondering if I can use this on a stock 305?? Basically I wanna build a 350 eventually, but I wanna mod my 305 and play around abit with it. I realize I will have to change my throttle body to match. Its a throttle body injection manifold from a 1993 Caprice 9C1.

The guy said he "recently converted the L05 system to an Edelbrock Multi-Point injection system and no longer need this intake. I had it steam cleaned (some tough dirt is still hanging in there anyhow) and ported to accept either a Holley 670cfm (2 inch) truck TB or a GM 454 (2 inch) throttle body."


------------------
Godti
'89 Trans Am (Red)
305 TBI 5spd

[This message has been edited by Godti (edited January 13, 2001).]

 

sure why not? its a small block chevy. I dout you'll see ANY improvement.

------------------
-Tas
'89 Formula WS-6
[soon to be Torch Red with black hood and headlights =) ]

305, TBI, auto, 14x3 chrome flat based open element with K&N, functional Formula hood, cross-flow Flowmaster, '99z28 rear pipes and tips....

Super GRK_Taz World
EFI & Intake Options
AOL IM: superGRtaz
ICQ 82881207

 

Im also going to do the heads and port and polish and a new cam. If I change the Throttle body and get a chip, I should get bit out of the engine, right??

------------------
Godti
'89 Trans Am (Red)
305 TBI 5spd