Hopefully this is a simple question with an easy "answer".

I'm in the process of cleaning and painting my engine bay. I have almost all the wiring removed except...on the driver's side, right next to the brake master there are two plug-ins that don't seem to simply "unplug". They appear to come from right under the driver's side wiper (actually there were another set of plug-ins on a bracket just above them ...I removed them and the bracket). All the other plugs just unclip, but these two when I unclip them the wiring doesn't seem to actually just unplug from the connector. I was tired and I didn't feel like tugging on them, so maybe I'm missing something??? How do I "unplug" these sets of wires so I can hang the entire harness out of the way and get to work on the bay?

Does anyone know what I'm talking about?

I've attached a couple of photos...

 

There is a bolt in there right in the center, unscrew that aand it comes right off.

 

Thanks cooter, I just went out and popped it off ...I probably never would have found that little bolt in there.

 

Glad i could help, post some pictures after your done

 

When it's done I'll put the photos up ...I'm not sure how long it will take me, I have several things going now and I don't know how my time will be over the next little while.

I did the rear-end and underbody last summer ...here's the link.

https://www.thirdgen.org/forums/auto...underbody.html