J-money

I just added the injector spacer mod under my injector pod and I have badly cross threaded one of the threads in the pod that the nuts go in. I havent had a chance to try a thread chaser to rethread them but its in pretty bad shape. My question is if I have to get a new pod, will the pod off from any 3rd gen TBI engine work for my 92 TBI?

one92rs

iTrader: (5)

THE NUTS???? screws hold the injector pod down. do you mean one of the fuel line adaptors??

J-money

yes the part that connects from the back of the pod to the fuel lines.

UnderCover89TBI

iTrader: (25)

ok so did you strip the theads where the fuel line's screw in? or where those fuel fittings screw into the pod? if its the latter, it'd be easiest to go to the junkyard and get another one...you could try rethreading it...

J-money

where the fittings screw into the pod. Any idea how much one of those would cost at a junk yard? I seen a few on ebay for around 40$

one92rs

iTrader: (5)

get another one. fuel is not the fluid to be leaking on a hot engine.,

J-money

ok I figured I would have to get another one. Ok one last quick question, when I swap my injectors into a new pod should I go ahead and get new O-rings to go with it?

UnderCover89TBI

iTrader: (25)

it woudlnt hurt too!

J-money

Ok Im assuming all the injector pods for the different years TBI engines are the same then. Alright guys thanks for the help I really appreciate it.

UnderCover89TBI

iTrader: (25)

basically. you'll find one pretty easily

EagleMark

As far as the hundred or so I have worked on they are all the same except for an industrail 366 big block.