Need help identifying these parts after swap
Thread Starter
Member
Joined: Feb 2006
Posts: 499
Likes: 0
From: Rock Hill, SC
Car: 91 GTA
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: stock
Need help identifying these parts after swap
I'm finishing up my 305 to 350 swap and I remembered where most everything goes except for these two parts. The first connector I can't seem to find a place for anywhere. All my sensors and other electronics are accounted for (as far as I can tell)...The second is a ground, but to what? I can't for the life of me remember where I took this off of the car and if I still need it. Any help you guys can give would be much appreciated.
Supreme Member
iTrader: (3)
Joined: Jun 2009
Posts: 2,350
Likes: 3
From: Mid West
Car: '87 Camaro
Engine: '92 Carb'd 350
Transmission: 700r4
Axle/Gears: factory stock
Re: Need help identifying these parts after swap
Second pic,
Ground from passenger side head to firewall
Ground from passenger side head to firewall
Supreme Member
iTrader: (3)
Joined: Jun 2009
Posts: 2,350
Likes: 3
From: Mid West
Car: '87 Camaro
Engine: '92 Carb'd 350
Transmission: 700r4
Axle/Gears: factory stock
Re: Need help identifying these parts after swap
Second pic,
Ground from passenger side head to firewall or top trans bolt
Ground from passenger side head to firewall or top trans bolt
Supreme Member
iTrader: (3)
Joined: Jun 2009
Posts: 2,350
Likes: 3
From: Mid West
Car: '87 Camaro
Engine: '92 Carb'd 350
Transmission: 700r4
Axle/Gears: factory stock
Re: Need help identifying these parts after swap
Second pic,
Ground from passenger side head to firewall or top trans bolt, one of those 2 places
Ground from passenger side head to firewall or top trans bolt, one of those 2 places
Thread Starter
Member
Joined: Feb 2006
Posts: 499
Likes: 0
From: Rock Hill, SC
Car: 91 GTA
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: stock
Re: Need help identifying these parts after swap
thanks t-top havoc...After doing some searching I believe that the connector in the first pic may be for the EGR solenoid but I haven't been able to find any descriptions or pictures of the connector. Can anybody confirm this?
Thread Starter
Member
Joined: Feb 2006
Posts: 499
Likes: 0
From: Rock Hill, SC
Car: 91 GTA
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: stock
Re: Need help identifying these parts after swap
yep thats what it was. Thanks RF.
I have one more question if anybody knows it. I have a vacuum tee fitting with a short piece of 1/4" vacuum hose coming off one end and I don't know where it goes. One end of the tee goes to something (don't know what it is) near the evap canister and the other goes through the firewall. I just don't know where/what the 1/4" line goes to.
I have one more question if anybody knows it. I have a vacuum tee fitting with a short piece of 1/4" vacuum hose coming off one end and I don't know where it goes. One end of the tee goes to something (don't know what it is) near the evap canister and the other goes through the firewall. I just don't know where/what the 1/4" line goes to.
Thread
Thread Starter
Forum
Replies
Last Post
Linson
Auto Detailing and Appearance
40
Aug 21, 2015 02:12 PM




