rpms jump up and down
Thread Starter
Junior Member
Joined: Aug 2009
Posts: 89
Likes: 0
Car: 1991 camaro z28 convertible
Engine: 5.0 v8
Transmission: 700r4
Axle/Gears: 9 bolt 3.23 borg worner
rpms jump up and down
I changed the manifold on my motor. When i put everything back together i started the car set the timing and the rpms will go up and down i get no throttle responce at all. Ive changed the fuel filter, cap and rotor, the iac in the tb and nothing has worked
Last edited by littlevin91; Sep 21, 2012 at 03:42 PM.
Thread Starter
Junior Member
Joined: Aug 2009
Posts: 89
Likes: 0
Car: 1991 camaro z28 convertible
Engine: 5.0 v8
Transmission: 700r4
Axle/Gears: 9 bolt 3.23 borg worner
Re: rpms jump up and down
Itll rev in neutral and park no problem but it i put.it in drive or anyother gear n give it gas the rpms drop and.it dies
Joined: Dec 2005
Posts: 6,499
Likes: 31
From: Macon, GA
Car: 1992 Camaro RS
Engine: Vortec headed 355, xe262
Transmission: T56
Axle/Gears: 9-bolt 3.70
Re: rpms jump up and down
Make sure all your vacuum lines are connected and make sure the timing is correct. DISCONNECT THE ESC PLUG TO SET TIMING TO ZERO! Then turn off and reconnect ESC and see if it helps.
Thread Starter
Junior Member
Joined: Aug 2009
Posts: 89
Likes: 0
Car: 1991 camaro z28 convertible
Engine: 5.0 v8
Transmission: 700r4
Axle/Gears: 9 bolt 3.23 borg worner
Re: rpms jump up and down
all the lines are connected and when i did the timing i unplugged the est and the timings on
Member
iTrader: (7)
Joined: Dec 2005
Posts: 276
Likes: 9
From: Beautiful Coastal New Jersey
Car: 1990 Firebird
Engine: 350 TBI
Transmission: T5
Axle/Gears: Auburn posi 3.73
Re: rpms jump up and down
What manifold did you put on? If its not a stock one, or close to it, you may need to do some prom tuning.
Thread
Thread Starter
Forum
Replies
Last Post
MikkoV
TPI
2
Sep 9, 2015 04:25 PM







