Injector wires
Thread Starter
Junior Member
Joined: Feb 2011
Posts: 82
Likes: 0
Car: 92 camaro RS
Engine: Moded 350 engine
Transmission: 5 speed
Injector wires
So I am doing a 305 to 350 swap. There is one harness that goes over the top of the engine and down to the starter. This harness has the injector wires that go into the TBI unit. What's the best way to get the wires out of the TBI unit with out breaking the clips that go on the injectors them self?
Joined: Dec 2004
Posts: 16,736
Likes: 993
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Injector wires
Your question is not clear, are you asking how to remove the harness from tb ? If so take off the air horn gasket and slide the rubber grommet out of the tb.
Thread Starter
Junior Member
Joined: Feb 2011
Posts: 82
Likes: 0
Car: 92 camaro RS
Engine: Moded 350 engine
Transmission: 5 speed
Re: Injector wires
i actually just figured out my problem. the wires are in a rubber thing and it slides out of the TBI unit.
thanks for the reply
thanks for the reply
Joined: Dec 2004
Posts: 16,736
Likes: 993
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Thread
Thread Starter
Forum
Replies
Last Post
Street Lethal
Power Adders
634
Apr 30, 2019 12:14 PM