Wondering about a polic injector flow rate for my build
Thread Starter
Member
Joined: Sep 2014
Posts: 263
Likes: 0
From: Portsmouth, Virginia
Car: 92 Camaro
Engine: 305
Transmission: 700r4
Axle/Gears: stock
Wondering about a polic injector flow rate for my build
I'm getting a custom chip for my 92 rs 305. The guy doing the chip said to go with 350 injectors preferably police package ones. Well I found 2 of them and was wondering if anyone new their flow rate . I understand it takes 1/2 lb of fuel to make 1hp roughly. The info, I found was that these are roughly 75lb injectors, I don't know if that's correct?
Junior Member
Joined: Mar 2004
Posts: 83
Likes: 1
From: Macungie, PA
Car: '87 IROC (TPI 350), '01 Corvette, '
Engine: '90 Corvette 350, blueprinted and b
Transmission: 700 R-4, with stage 2 shift kit
Axle/Gears: 3.23
Re: Wondering about a polic injector flow rate for my build
I know this is an old thread but I would suggest reading the information on: http://www.dynamicefi.com/TBI_Fueling.php
The information you want on fuel needed and injector sizes is listed on that site,
The information you want on fuel needed and injector sizes is listed on that site,
Thread
Thread Starter
Forum
Replies
Last Post