cam install question
Thread Starter
Joined: Jan 2001
Posts: 948
Likes: 0
From: Fresno, CA
Car: 87 Z28
Engine: LT1
Transmission: T-56
cam install question
im isntalling the lt1 cam just like sonar-un, and he didnt replace his valve springs, but i have heard that you should... what y'all think?...my motor has 80k miles on it.
Member
Joined: May 2001
Posts: 201
Likes: 0
From: Yorktown, VA
I replaced mine...I have 128,000 on my engine so it was cheap insurance while I had everything off. I used K-motion's K-700 springs. Cost 42.99 from summit. I need to do some fuel pressure tuning but it pulls hard until 5500
Supreme Member
iTrader: (1)
Joined: Jun 2001
Posts: 1,520
Likes: 0
From: 600 yds out
Car: Bee-Bowdy
Engine: blowd tree-fity
Transmission: sebin hunnerd
Axle/Gears: fo-tins
I just installed a 196/206 @ .050" .431/.451 GMPP cam and I used a set of Comp Cams 105# springs.
I would change them while you're in there. It's cheap insurance. I did mainly because I went from a flat tappet to a roller cam.
I would change them while you're in there. It's cheap insurance. I did mainly because I went from a flat tappet to a roller cam.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM
84z96L31vortec
North East Region
1
Aug 10, 2015 08:27 PM