I am wanting to egt a good cam but am limted to around 200 bucks i will have edelbrock performer rpm heads model #60739 and a 350 stock freshley rebuilt what is a good cam to go with and i also will be running an edelbrock 600cfm carb #1405 also abnyone know what kinda horse power ill be getting with this setup????

 

what gears are you running?

an all around good cam would be a comp cams x/e 268, its about 150$$ lifters included, I would also spend another 100$$ or so and buy a covete torque converter.

Without knowing what rear gears you have, its impossible to say what cam would be the best though

 

looking for roller or flat tappet? why such a small carb? and do you think someone is going to pull your hp number out of their *** or something?

 

nah just wanted a rough estimate why sucks small carb u ask gass milage its going to be a daily driving car ....

 

and roller cam not tapped

 

so again, what gears are you running?

600cfm is just fine on a mild 350, thats what I run, but I still get horrible mileage. 11mpg is a good day for me.

 

With those heads and a 268 cam and about 9.5:1 cp,you should make at least 350 hp maybe a little more,it's hard to give a more accurate esmt. because of variables. A 600 cfm is big enough just don't be afraid to play with rods and jets for best performance!