ZIF-to-ECM/EPROM/Memcal Adapters
Thread Starter
Supreme Member
Joined: Jul 1999
Posts: 1,577
Likes: 0
From: Baton Rouge, LA, USA
Car: 87 T/A
Engine: 441 SBC 12.5:1 0.680" Lift
Transmission: T-56
Axle/Gears: 4.10 TruTrac Moser 9"
ZIF-to-ECM/EPROM/Memcal Adapters
Folks,
Want to do some of your own EPROM programming? Check this out:
If anyone is in need of a Memcal/ZIF/ECM/EPROM adapter, a few Flash chips, or a ZIF or two, just let me know. If you have any questions, just let me know.
Photos of adapter installation:
<img src="http://members.***.net/fcmoates01/install-s.jpg">
Click here to see more information:
http://ice.prohosting.com/moates/gmecm/hardware.htm
Best regards,
-Craig
Want to do some of your own EPROM programming? Check this out:
If anyone is in need of a Memcal/ZIF/ECM/EPROM adapter, a few Flash chips, or a ZIF or two, just let me know. If you have any questions, just let me know.
Photos of adapter installation:
<img src="http://members.***.net/fcmoates01/install-s.jpg">
Click here to see more information:
http://ice.prohosting.com/moates/gmecm/hardware.htm
Best regards,
-Craig
Thread
Thread Starter
Forum
Replies
Last Post
