Does anybody have a clue as to there the MAT relocation kit from TPIS plugs into? I can't trace the wire back to see where it connects to since its in loom that runs to the back of the motor and splits off in two directions and I can't get the wire out of the loom (taped in there). So if anybody has any clue as to where the wire harness for the MAT sensor plugs into, I'd appreciate it. Again, this is not the end w/ the sensor, but the other end that is supposed to connect to the computer somewhere. All i'm managing to find is a bunch of connectors w/ a lot of wires, and not the two-prong connector i'm looking for

 

ttt

 

I'm not sure on a TBI, but on my TPI the MAT sensor connector is right next to the distributor. Tracing the wires by colors can help.